Choose Oil

Tanin remover

Limespot remover

from £69.00
£69.00
£69.00
£69.00
£69.00
£69.00
£69.00
£69.00
£69.00
Choose the variation, then you can add to cart
Qty

Repair Kit

Repair kit includes Oil 20ml, Tanin Remover 100mlLimespot remover 100ml, and oilcloth.

Oil Plus 2C is a wood protector that colors and protects in only 1 single layer! It protects wood from water, heat and daily wear & tear. It is the best oil for wood furniture, especially oak and walnut tables. Choose oil by your tabletop colour.
 
Application:
  1.   Untreated wood: sand scratch-free without over-polishing the surface. Thoroughly remove sanding dust with a vacuum cleaner and remove the remaining dust particles. Open wood pores guarantee a long-lasting finish and are essential for the absorption of the oil. We therefore strongly recommend moistening the surface evenly with water (water popping).
  2.  Carefully mix the two components (1 to 2 minutes) with a ratio of appr. 3 units A to 1 unit B.
  3.  Once the cleaned surface is dry, spread out a small quantity of Oil Plus 2C. Work in zones of 5 - 10 m².
  4.  Let absorb it during a few minutes. Thoroughly remove all excess of oil within 15 minutes per zone. The surface should feel dry! Finish all zones the same way.
  5.  In a well-ventilated room, the surface can be used 24 - 36 hours after the application
 
Tannin Remover is a ready-to-use product for removing stains and spots on wood caused by a reaction to acid and water. These spots tend to occur after coming into contact with moisture and metal. 
  • ​Black/tannin stains e.g. rings/stains from cans, flower pots, etc.
  • It can also be used: - after water damage on the parquet. - in case of efflorescence on exterior wood (on the bottom of gates, doors, on walls).
  • Can be used on untreated, oiled and waxed surfaces.
  • Also suitable for outdoor applications

Application:

  1.   Spray Tannin Remover on the spot or stain.
  2.  Allow several minutes for absorption.
  3.  Use a damp cloth to remove the stain.
  4.  To remove stubborn stains, it is recommended to repeat the process until the desired result is achieved.
  5.  Allow the surface area to dry.
  6.  If the protective layer is affected: treat the surface area again with Oil Plus 2C.

We highly recommend that you first test the product on a non-visible part of the wood, to test the effect of the product on your specific wood type

Limespot Remover is a ready-to-use product that removes lime spots from a surface treated with Oil. 
 
Application:
  1.  Spray Limespot Remover on the stain.
  2.  Allow several minutes for absorption.
  3.  Dab dry using a cloth or paper towel.
  4.  Rinse the whole surface thoroughly using a damp cloth.